Materials:
Any gift in the box, for example, a designer
Metal film, 1 sheet, 100x140 cm (40 rubles / sheet)
Packing tape with a width of 2 cm, 3.5 m (10 rubles / m)
The total cost of the package is 75 rubles.
Instruments:
Double-sided packing tape, chancery scotch.
1. Place a box on the middle of the film sheet - face down. Slide it so that the edge of the film wraps the end of the box with a margin of 1.5 cm. Secure this edge with a piece of tape, gluing it to the box. Wrap the box with film and cut off excess so that the bound edge overlaps the glued edge with a margin of 1.5-2 cm. Fold this edge so that the fold lies on the edge of the box. Fix it with pieces of scotch tape.
2. Cut the film from the remaining two sides, leaving the allowances - 2/3 of the height of the sides. Wrap the corners as a "butter briquette" starting at the top edge. Then wrap the sides. Lower the bottom edge before gluing.
3. Turn the crown over and tie it with two pieces of packing tape criss-crosswise. Tape the tape from above. The bow will be located in the middle.
4. Make a bow-ball, freely wrapping around the wrist with 11 turns of tape. Fold them in half and cut the corners in a semicircle.
5. Insert a narrow ribbon into the bend and tie a tight knot.
6. Straighten from the middle of the "petals" and twice turn each at the base counter-clockwise, simultaneously pull them up, with your left hand holding at the base. Glue the resulting bow at the intersection of the tapes with a double-sided tape.
Tip
> For the male category, you can offer packaging in the "jubilee" style. Wrap the shirt with bright tissue paper and put it in a box of the appropriate size. Decorate the box lid with a strip of about 18-20 cm wide. Cut three strips equal to the width of the box, adding the allowances so that they can be bent under the lid. Also measure three more - along the length of the box. Wrap the longitudinal edges of the bands inside and fix them with adhesive tape. Wrap the cover with three horizontal stripes. To do this, put her "face" down in the middle of one of them and round it with a lid, dropping both ends inside. Fold the edges of the strip and secure the lid inside the cover with adhesive tape. The other two strips are fixed on the cover in the same way. Go to the vertical bars: first fix the middle, then - the extreme ones. Make on the cover three decorative elements of the stripes. Connect the thread of their intersection. Using a glue gun, glue large crystals at the intersection, closing the auxiliary nodes.
> When starting to wrap any box, position it so that the top is on the left. Then in the unfolded form, the gift will not turn upside down.
> Remember that on a rectangular box the bow should be located in the upper left corner - as is customary in Europe. The right upper corner is decorated only in the East.
> Pack a few gifts with the same paper.